Differences

This shows you the differences between two versions of the page.

--- hypervisor:exp1 [2012/11/15 13:14]
giancarlo
+++ hypervisor:exp1 [2012/11/15 13:37] (current)
giancarlo
@@ Line 57: / Line 57: @@
 </WRAP>
+  * Remove libvirt default network
+<WRAP prewrap center>
+<code>
+# virsh net-destroy default
+# virsh net-autostart --disable default
+</code>
+</WRAP>
   * Edit OpenvSwitch conf
@@ Line 77: / Line 85: @@
 </WRAP>
+  * Edit interfaces
+Remove dummy entries in /etc/network/interfaces
+<WRAP prewrap center>
+<code>
+# nano -w /etc/network/interfaces
+auto eth0
+iface eth0 inet manual
+up ifconfig $IFACE 0.0.0.0 up
+down ifconfig $IFACE down
+auto br0
+iface br0 inet manual
+up ifconfig $IFACE 0.0.0.0 up
+down ifconfig $IFACE down
+</code>
+</WRAP>
+  * Reboot
   * Configure KVM network
-  * VM network example
+<WRAP prewrap center>
+<code>
+# nano -w mynet-ovs.xml
+</code>
+</WRAP>
+<WRAP prewrap center>
+<code xml>
+<network>
+  <name>ovs-network</name>
+  <forward mode='bridge'/>
+  <bridge name='br0'/>
+  <virtualport type='openvswitch'/>
+  <portgroup name='vmport0' default='yes'>
+  </portgroup>
+  <portgroup name='vmport2'>
+    <vlan trunk='yes'>
+      <tag id='0'/>
+      <tag id='2'/>
+      <tag id='3'/>
+    </vlan>
+  </portgroup>
+</network>
+</code>
+</WRAP>
+<WRAP prewrap center>
+<code>
+# virsh net-define mynet-ovs.xml
+# virsh net-start
+</code>
+</WRAP>
+  * VM network example
+<WRAP prewrap center>
+<code xml>
+    <interface type='network'>
+      <mac address='52:54:00:bd:6c:2a'/>
+      <source network='ovs-network' portgroup='vmport0'/>
+      <target dev='vnet0'/>
+      <alias name='net0'/>
+      <address type='pci' domain='0x0000' bus='0x00' slot='0x03' function='0x0'/>
+    </interface>
+</code>
+</WRAP>
 <WRAP right 35% rightalign lo>