Differences
This shows you the differences between two versions of the page.
| Both sides previous revision
Previous revision
Next revision
|
Previous revision
|
hypervisor:exp1 [2012/11/15 13:21]
giancarlo |
hypervisor:exp1 [2012/11/15 13:37]
giancarlo |
| |
| * Reboot | * Reboot |
| | |
| | * Configure KVM network |
| |
| <WRAP prewrap center> | <WRAP prewrap center> |
| <code> | <code> |
| # reboot | # nano -w mynet-ovs.xml |
| </code> | </code> |
| </WRAP> | </WRAP> |
| |
| * Configure KVM network | <WRAP prewrap center> |
| | <code xml> |
| | <network> |
| | <name>ovs-network</name> |
| | <forward mode='bridge'/> |
| | <bridge name='br0'/> |
| | <virtualport type='openvswitch'/> |
| | <portgroup name='vmport0' default='yes'> |
| | </portgroup> |
| | <portgroup name='vmport2'> |
| | <vlan trunk='yes'> |
| | <tag id='0'/> |
| | <tag id='2'/> |
| | <tag id='3'/> |
| | </vlan> |
| | </portgroup> |
| | </network> |
| | </code> |
| | </WRAP> |
| | |
| | <WRAP prewrap center> |
| | <code> |
| | # virsh net-define mynet-ovs.xml |
| | # virsh net-start |
| | </code> |
| | </WRAP> |
| |
| * VM network example | * VM network example |
| |
| | <WRAP prewrap center> |
| | <code xml> |
| | <interface type='network'> |
| | <mac address='52:54:00:bd:6c:2a'/> |
| | <source network='ovs-network' portgroup='vmport0'/> |
| | <target dev='vnet0'/> |
| | <alias name='net0'/> |
| | <address type='pci' domain='0x0000' bus='0x00' slot='0x03' function='0x0'/> |
| | </interface> |
| | </code> |
| | </WRAP> |
| |
| <WRAP right 35% rightalign lo> | <WRAP right 35% rightalign lo> |
